Patton SmartNode 4110 User Manual download pdf (Page 14)

SmartNode Series VoIP routers overview 14

SmartNode 4520 & 4110 Series User Manual 1 • General information

Ports descriptions

The SmartNode 4520 Series rear panel ports are described in table 2.

Reset button behavior

For those SmartNode devices that have a Reset button on the rear panel, its behavior is as follows:

• To restart the unit with the current startup configuration—Press for less than 1 second and release the Reset

button. The SmartNode will restart with the current startup configuration.

• To restart the unit with factory default configuration—Press the Reset button for 5 seconds until the Power

LED starts blinking. The unit will restart with factory default configuration.

• To restart the unit in bootloader mode (to be used only by trained SmartNode technicians)—Start with the

unit powered off. Press and hold the Reset button while applying power to the unit. Release the Reset button

when the Power LED starts blinking so the unit will enter bootloader mode.

Table 2. Rear panel ports

Port Location Description

10/100 Ethernet

ETH 0/0 & ETH 0/1

Rear panel

RJ-45 connectors (see

figure 16

on page 32) that connect the router to an

Ethernet device (e.g., a cable or DSL modem, LAN hub or switch).

Analog voice port,

FXS

Rear panel

FXS RJ-11(6 position, 4 wire) connectors (see

figure 16

on page 32) that

connect the router with an analog terminal (a telephone, for example) FXO

port. EuroPOTS support (ETSI EG201 188). FXS on-hook voltage is 48V

for each FXS port.

Analog voice port,

FXO

Rear panel

FXO RJ-11(6 position, 4 wire) connectors (see

figure 16

on page 32) that

connect the router with an analog line (FXS port). EuroPOTS support (ETSI

EG201 188).

Power Rear panel The gateway is available in a DC or AC power input version (see

figure 3

), labeled as follows:

•

AC version (Internal power supply): 100–240 VAC, 50/60 Hz, 200 mA

•

DC version: 12 VDC, 1.25 A

Console Front panel

Used for service and maintenance, the Console port (see

figure 4

on page 15),

an RS-232 RJ-45 connector, connects the router to a serial terminal such as a PC

or ASCII terminal (also called a dumb terminal).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 77 78

Comments to this Manuals

No comments

Patton SmartNode 4110 User Manual Page 14

Comments to this Manuals